Home › BODY ELECTRICAL › LIGHTING › HIGH INTENSITY DISCHARGE HEADLIGHT BULB

HIGH INTENSITY DISCHARGE HEADLIGHT BULB > REMOVAL

for Preparation Click here



1. PRECAUTION (w/ Navigation System)

NOTICE:
After the ignition switch is turned off, the navigation receiver assembly (HDD navigation system) records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE)


    B138886
  1. Remove the 7 clips and cool air intake duct seal.



4. REMOVE HEADLIGHT SOCKET COVER


    E180303
  1. Turn the headlight socket cover in the direction indicated by the arrow shown in the illustration, and remove it.



5. REMOVE DISCHARGE HEADLIGHT BULB


    E180304
  1. Separate the light control ECU socket as shown in the illustration.



    E180305E01
  1. Release the set spring and remove the discharge headlight bulb as shown in the illustration.

    NOTICE:
    Do not touch the bulb glass.