Home › SERVICE SPECIFICATIONS › SERVICE SPECIFICATIONS › 2AZ-FE CHARGING

2AZ-FE CHARGING > TORQUE SPECIFICATIONS



Part Tightened
N*m
kgf*cm
ft.*lbf
Bearing retainer plate x Generator drive end frame
2.3
23
20 in.*lbf
Generator coil assembly x Generator drive end frame
5.8
59
51 in.*lbf
Generator brush holder assembly x Generator coil assembly
1.8
18
16 in.*lbf
Generator rear end cover x Generator coil assembly
4.6
47
41 in.*lbf
Clutch pulley x Generator rotor assembly
111
1,125
81
Generator assembly x Cord clip
4.6
47
41 in.*lbf
Generator assembly x Wire harness bracket
8.4
86
74 in.*lbf
Bolt A: Generator assembly x Cylinder block
21
215
16
Bolt B: Generator assembly x Cylinder block
52
530
38
Generator wire x Terminal B
9.8
100
87 in.*lbf