Home › RESTRAINTS › SEAT BELT › OCCUPANT DETECTION SENSOR (for Manual Seat)

OCCUPANT DETECTION SENSOR (for Manual Seat) > INSTALLATION

for Preparation Click here



1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION PAD


    B140572E01
  1. Using hog ring pliers, install the separate type front seat cushion cover to the separate type front seat cushion pad with 16 new hog rings.

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD


3. INSTALL FRONT INNER SEAT CUSHION SHIELD RH


4. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH


    B132035E01
  1. Install the front seat inner belt assembly with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding parts of the front seat adjuster.



    B132032E02
  1. for Driver seat:

    1. Connect the connectors and engage the 4 clamps.

  1. for Passenger seat:

    1. Connect the connector and engage the 3 clamps.



5. INSTALL FRONT SEAT CUSHION SHIELD RH


6. INSTALL RECLINING ADJUSTER RELEASE HANDLE RH


7. INSTALL FRONT SEAT ASSEMBLY RH
  1. Place the front seat assembly in the vehicle and align the adjuster pin with the hole on the vehicle side.

  1. Connect the connector and clamp.

  1. Move the front seat assembly to the rearmost position by operating the slide handle.

    NOTICE:
    Check that the seat is locked.



    B147667
  1. Temporarily install the front seat track bracket with the 2 bolts.

  1. Move the front seat assembly fully forward by operating the slide handle.

    NOTICE:
    Check that the seat is locked.



    B147668
  1. Temporarily install the rear seat track bracket with the 2 bolts.

  1. Move the front seat assembly to the rearmost position by operating the slide handle.

    NOTICE:
    Check that the seat is locked.

  1. Fully tighten the 2 bolts on the front seat track bracket in the order of the inner side bolt and then the outer side bolt.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Move the front seat assembly fully forward by operating the slide handle.

    NOTICE:
    Check that the seat is locked.

  1. Fully tighten the 2 bolts on the rear seat track bracket in the order of the inner side bolt and then the outer side bolt.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



8. INSTALL INNER SEAT TRACK BRACKET COVER RH


    B147666E01
  1. Slide the inner seat track bracket cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.

  1. Push the seat track bracket cover inner to engage claw B.



9. INSTALL SEAT TRACK COVER RH
  1. Slide the seat track cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.



    B147665E01
  1. Push the seat track cover to engage claw B.



10. INSTALL FRONT SEAT HEADREST ASSEMBLY


11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


12. INSPECT SLIDE ADJUSTER LOCK


13. INSPECT SRS WARNING LIGHT
(Click here)