Home › RESTRAINTS › SEAT BELT › OCCUPANT DETECTION SENSOR (for Power Seat)

OCCUPANT DETECTION SENSOR (for Power Seat) > INSTALLATION

for Preparation Click here



1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION PAD


    B144037E01
  1. Using hog ring pliers, install the separate type front seat cushion cover to the separate type front seat pad with 17 new hog rings.

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD


3. INSTALL FRONT POWER SEAT SWITCH


4. INSTALL FRONT INNER SEAT CUSHION SHIELD RH


5. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH


6. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY


7. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB


8. INSTALL RECLINING POWER SEAT SWITCH KNOB


9. INSTALL FRONT SEAT ASSEMBLY RH
  1. Place the seat in the cabin.

  1. Connect the connectors under the seat.

  1. Connect the cable to the negative (-) battery terminal.

  1. Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.

    NOTICE:
    Check that the seat is locked.



    B147669
  1. Temporarily install the front side of the front seat assembly with the 2 bolts.

  1. Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.

    NOTICE:
    Check that the seat is locked.



    B147675
  1. Temporarily install the rear side of the front seat assembly with the 2 bolts.

  1. Move the front seat assembly to the rearmost position by operating the slide and vertical power seat switch knob.

    NOTICE:
    Check that the seat is locked.

  1. Fully tighten the 2 bolts on the front side of the front seat assembly in the order of the inner side bolt and then the outer side bolt.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.

    NOTICE:
    Check that the seat is locked.

  1. Fully tighten the 2 bolts on the rear side of the front seat assembly in the order of the inner side bolt and then the outer side bolt.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



10. INSTALL INNER SEAT TRACK BRACKET COVER LH


    B147666E01
  1. Slide the inner seat track bracket cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.

  1. Push the inner seat track bracket cover to engage claw B.



11. REMOVE SEAT TRACK COVER RH


    B147665E01
  1. Slide the seat track cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.

  1. Push the seat track cover to engage claw B.



12. REMOVE FRONT SEAT HEADREST ASSEMBLY


13. INSPECT SRS WARNING LIGHT
(Click here)


14. INSPECT FRONT SEAT ASSEMBLY
  1. Check the power seat operation.

  1. Check the seat heater operation (with seat heater system).

    1. Turn the ignition switch on (IG).

    2. Turn the seat heater switch ON.

    3. Wait 5 minutes or more and confirm that the seat surface becomes warm.