Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CRUISE CONTROL MAIN SWITCH


  1. Remove the cruise control main switch.


    E106137E06

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:

    Tester Connection
    Switch Condition
    Specified Condition
    A-1 (CCS) - A-3 (ECC)
    Neutral
    10 kΩ or higher
    + (ACCEL)/RES (RESUME)
    216 to 264 Ω
    - (COAST)/SET
    567 to 693 Ω
    CANCEL
    1,386 to 1,694 Ω
    Main Switch on
    Below 1 Ω

    If the result is not as specified, replace the cruise control main switch