Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CLUTCH SWITCH

CLUTCH SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CLUTCH SWITCH


    E133093E02
  1. Remove the clutch switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Switch pin free (Clutch pedal depressed)
    10 kΩ or higher
    Switch pin pushed in (Clutch pedal released)
    Below 1Ω

    If the result is not as specified, replace the cruise control main switch