LIGHTING SYSTEM > Engine Switch Illumination Circuit |
| Operation | Condition |
| Fade in | When any of the following conditions is met, the engine switch illumination will fade in.
|
| Fade out immediately | When either of the following conditions is met, the engine switch illumination will fade out.
|
| Illuminate for approximately 15 seconds, and then fade out | All doors are closed when the engine switch is off. |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn intelligent tester on.
Select the following menu items: Body Electrical / Main Body / Active Test.
Check the operation.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicator for Lighting | Engine switch illumination | ON / OFF | - |
|
| ||||
| NG | |
| 2.INSPECT ENGINE SWITCH |
Remove the engine switch.

Apply the battery voltage to the engine switch.
Check that the illumination comes on.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 11 (SWIL) Battery negative (-) → Terminal 5 (GND) or 4 (COM) | Engine switch illumination comes on |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR |
![]() |
Disconnect the E7 main body ECU connector.
Disconnect the E52 engine switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E52-11 (SWIL) - E7-25 (SWIL) | Always | Below 1 Ω |
| E52-4 (COM) or E52-5 (GND) - Body ground | Always | Below 1 Ω |
| E7-25 (SWIL) - Body ground | Always | Below 10 kΩ or higher |
|
| ||||
| OK | ||
| ||