Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Microphone Circuit between Microphone and Navigation Receiver Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the telephone microphone assembly to the navigation receiver assembly.
It also supplies power from the navigation receiver assembly to the telephone microphone assembly.

WIRING DIAGRAM


E185300E04


INSPECTION PROCEDURE

1.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E168561E26
  1. Disconnect the navigation receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F24-5 (MACC) - Body ground
    Ignition switch ACC
    4 to 6 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F24-14 (SGND) - Body ground
    Always
    Below 1 Ω
    F24-13 (MIN-) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Component with harness connected
    (Navigation Receiver Assembly)



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEPHONE MICROPHONE ASSEMBLY)


    E168561E27
  1. Disconnect the navigation receiver assembly connector.



    E176476E05
  1. Disconnect the telephone microphone assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F24-3 (SNS2) - Q13-4 (SNS2)
    Always
    Below 1 Ω
    F24-5 (MACC) - Q13-1 (ACC)
    Always
    Below 1 Ω
    F24-4 (MIN+) - Q13-3 (MI1+)
    Always
    Below 1 Ω
    F24-13 (MIN-) - Q13-5 (MIC-)
    Always
    Below 1 Ω
    F24-3 (SNS2) - Body ground
    Always
    10 kΩ or higher
    F24-5 (MACC) - Body ground
    Always
    10 kΩ or higher
    F24-4 (MIN+) - Body ground
    Always
    10 kΩ or higher
    F24-13 (MIN-) - Body ground
    Always
    10 kΩ or higher
    F24-14 (SGND) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Navigation Receiver Assembly)
    *2
    Front view of wire harness connector
    (to Telephone Microphone Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT MICROPHONE


    E176581E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Q13-4 (SNS2) - Q13-5 (MIC-)
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Component without harness connected
    (Telephone Microphone Assembly)



NG
REPLACE TELEPHONE MICROPHONE ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)