WIPER AND WASHER SYSTEM > Speed Signal Circuit |
| 2AZ-FE |

| 2GR-FE |

| 1.CHECK COMBINATION METER SYSTEM |
The circuits that send vehicle speed signals to this system are inspected in the meter system (Click here).
During inspection for the meter section, if there is an instruction that indicates to go back inspections for each system, proceed to the next step.
| NEXT | |
| 2.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - COMBINATION METER) |
![]() |
Disconnect the windshield wiper relay assembly connectors E26 and combination meter connector F2.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E26-19 (SPD) - F2-12 (+S) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - NO. 3 J/B) |
Disconnect the 3J No. 3 J/B connector.
Measure the resistance according to the value(s) in the table below.

| Tester Connection | Condition | Specified Condition |
| 3J-9 - E26-19 (SPD) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||