NAVIGATION SYSTEM > Navigation Receiver Assembly Power Source Circuit |

| 1.INSPECT NAVIGATION RECEIVER ASSEMBLY |
![]() |
Disconnect the navigation receiver assembly connector.
![]() |
Disconnect the navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below .
| Tester Connection | Condition | Specified Condition |
| F27-7 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F27-4 (B) - F27-7 (GND) | Always | 11 to 14 V |
| F27-3 (ACC) - F27-7 (GND) | Ignition switch ACC | 11 to 14 V |
| F25-2 (IG) - F27-7 (GND) | Ignition switch ON | 11 to 14 V |
| *1 | Front view of wire harness connector (to Navigation Receiver Assembly) |
| *2 | Front view of wire harness connector (to Navigation Receiver Assembly) |
|
| ||||
| OK | ||
| ||