ENTRY AND START SYSTEM > OPERATION CHECK |
| ENTRY AND START SYSTEM OPERATION INSPECTION |
Check the entry unlock function.
Use the wireless lock operation to lock the front door. With the key in your possession, touch a front door outside handle (touch sensor) and check that the door unlocks.
Check the entry unlock operation detection area.
Step 1: Hold the key at the same height as the door outside handle (approximately 0.8 m (2.62 ft.)). Pay attention to the direction of the key in the illustration.
![]() |
Step 2: Check that when the key is brought within 0.7 to 1.0 m (2.30 to 3.28 ft.) of the vehicle, the system enters unlock standby mode.
Step 3: After the system enters unlock standby mode, touch the outside handle sensor within 3 seconds. Check that the door unlocks.
Step 4: Repeat step 2 and step 3 for the remaining front door.
![]() |
Step 5: Inspect the touch sensor. Wear protective gloves, set the system to unlock standby mode, and check that touching the inner side of the outside handle (the highlighted area in the illustration) with your finger causes the door to unlock.
Step 6: Repeat step 5 for the remaining front door.
Check the entry lock function.
![]() |
Step 1: Close all of the vehicle doors. With the key outside the vehicle, check that pressing the lock switch locks the doors.
Step 2: Repeat step 1 for the remaining doors.
Check the entry luggage compartment door open function.
Close the luggage compartment door. With the key outside the vehicle, check that pressing the luggage door opener switch opens the luggage compartment door.
![]() |
Inspect the entry luggage compartment door open operation detection area. Hold the key at the same height as the luggage door opener switch (approximately 0.8 m (2.62 ft.)) aligning it with the center of the rear of the vehicle. Pay attention to the direction of the key shown in the illustration. Check that when the key is brought within 0.7 to 1.0 m (2.30 to 3.28 ft.) of the vehicle, pressing the luggage door opener switch opens the luggage compartment door.
Check the entry ignition function.
While holding the key, confirm that the engine switch indicator light illuminates green when the engine switch is off, the shift lever is in P and the brake pedal is depressed. With the engine switch indicator illuminates green, confirm that the engine starts when the engine switch is pressed.
While holding the key, confirm that the engine switch turns off → on (ACC) → on (IG) → off every time the engine switch is pressed when the brake pedal is not depressed.
With the engine running, vehicle stopped and shift lever in P, confirm that pressing the engine switch turns the engine off, and that the steering lock engages after opening the driver door.
![]() |
Inspect the entry ignition operation detection area (front seat). Pay attention to the direction of the key in the illustration. When the key is in either of the 2 locations in the illustration, check that the engine can start.
![]() |
Inspect the entry ignition operation detection area (rear seat). Pay attention to the direction of the key in the illustration. When the key is in either of the 2 locations in the illustration, check that the engine can start.
Check the key lock-in prevention function (for luggage compartment).
Place the key in the luggage compartment with all doors locked. Check that: 1) closing the luggage compartment door triggers the key wireless buzzer (which lasts approximately 2 seconds), and 2) pressing the luggage door opener switch opens the luggage compartment door.
![]() |
Inspect the key lock-in prevention detection area. Pay attention to the direction of the key shown in the illustration. When the key is in either of the 2 locations in the illustration, check that: 1) closing the luggage compartment door sounds the wireless buzzer, and 2) pressing the luggage door opener switch opens the luggage compartment door.
![]() |
Inspect the key lock-in prevention detection area and the entry door control receiver for wave leaks. Hold the key at the same height as the lower edge of the luggage compartment door aligning it with the center of the rear of the vehicle. Pay attention to the direction and position of the key shown in the illustration. Check that when the key is over 0.1 m (0.328 ft.) from the vehicle rear bumper, the wireless buzzer does not sound. If the warning buzzer sounds, the entry door control receiver may have a wave leak.
Check the key cancel function.
While the engine switch is on (IG), check that the luggage door opener switch is the only switch in the entry and start system that can be operated.
While the key cancel function (entry and start system cancel function) is on, check that all functions in the entry and start system cannot be operated.
Check the answer-back function (hazard warning light flashing).
| Entry Operation | Hazard Warning Light |
| Entry Door Lock | Flashes once |
| Entry Door Unlock | Flashes twice |
| Entry Luggage Compartment Door Open | Does not flash |
Check that the key reminder warning buzzer sounds.
Carry the key in the vehicle and close the driver side door. Then turn the engine switch off or on (ACC).
Open the driver side door and check that the buzzer sounds intermittently.
Check that the key reminder warning buzzer stops.
When the buzzer is sounding, check that the buzzer stops sounding if either of the following is performed:
| KEY DIAGNOSTIC MODE |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / Utility / Key Communication Check.
Check the values by referring to the table below.
| Tester Display | Inspection Range |
| Overhead + Driver Side*1 | Door electrical key oscillator (for driver side) |
| Overhead + Passenger Side*2 | Door electrical key oscillator (for front passenger side) |
| Overhead + Front Room*3 | Indoor electrical key oscillator (for front floor) |
| Overhead + Rear Room*4 | Indoor electrical key oscillator (for rear floor) |
| Overhead + Luggage (outside)*5 | Outside electrical key oscillator (for luggage compartment) |
| Overhead + Luggage (inside)*6 | Indoor electrical key oscillator (for luggage compartment) |
| Immobiliser Amp*7 | Amplifier (engine switch) |
When the electrical key transmitter is brought near the selected oscillator/amplifier, check that the wireless door lock buzzer sounds.
![]() |
*1: Door electrical key oscillator (for driver side)
![]() |
*3: Indoor electrical key oscillator (for front floor)
![]() |
*4: Indoor electrical key oscillator (for rear floor)
![]() |
*5: Outside electrical key oscillator (for luggage compartment)
![]() |
*6: Indoor electrical key oscillator (for luggage compartment)
![]() |
*7: Amplifier (engine switch)