DTC B1273 Sliding Roof ECU Communication Stop |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1273 | No communication between sliding roof ECU (Sliding roof drive gear sub-assembly) and main body ECU (Instrument panel junction block) for more than 10 seconds |
|

| 1.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 2.CHECK DTC OUTPUT |
Recheck for DTC (Click here).
| Result | Proceed to |
| B1273 is output | A |
| B1273 is not output | B |
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SLIDING ROOF ECU) |
Disconnect the E8 and Q12 connectors.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E8-10 (LIN2) - Q12-4 (MPX1) | Always | Below 1 Ω |
| E8-10 (LIN2) - Body ground | Always | 10 kΩ or higher |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E8-10 (LIN2) - Body ground | Always | Below 1 V |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SLIDING ROOF ECU - BATTERY AND GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Q12-2 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Q12-1 (B) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 5.REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) |
Replace the sliding roof ECU (Sliding roof drive gear sub-assembly) (Click here).
| NEXT | |
| 6.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Recheck for DTC.
| Result | Proceed to |
| B1273 is not output | A |
| B1273 is output | B |
|
| ||||
| A | ||
| ||