LIN COMMUNICATION SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Diagnosis / Body / Main body / Data list.
Read the Data List according to the display on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Communication D-Door Motor | Connection status between power window regulator motor (Driver side) and main body ECU (Instrument panel junction block) / OK or Stop | OK: Connection Stop: No connection | DTC is output if an error occurs in LIN communication |
| Communication Sliding Roof* | Connection status between sliding roof ECU (Sliding roof drive gear sub-assembly) and main body ECU (Instrument panel junction block) / OK or Stop | OK: Connection Stop: No connection | DTC is output if an error occurs in LIN communication |