LIN COMMUNICATION SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Diagnosis / Body / Main body / Data list.
Read the Data List according to the display on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Communication D-Door Motor | Connection status between power window regulator motor (for driver side) and main body ECU (instrument panel junction block)/OK or Stop | OK: Connected Stop: Not connected | DTC is output if an error occurs in LIN communication |
| Communication P-Door Motor*1 | Connection status between power window regulator motor (for front passenger side) and main body ECU (instrument panel junction block)/OK or Stop | OK: Connected Stop: Not connected | DTC is output if an error occurs in LIN communication |
| Communication RR-Door Motor*1 | Connection status between power window regulator motor (for rear RH side) and main body ECU (instrument panel junction block)/OK or Stop | OK: Connected Stop: Not connected | DTC is output if an error occurs in LIN communication |
| Communication RL-Door Motor*1 | Connection status between power window regulator motor (for rear LH side) and main body ECU (instrument panel junction block)/OK or Stop | OK: Connected Stop: Not connected | DTC is output if an error occurs in LIN communication |
| Communication Sliding Roof*2 | Connection status between sliding roof ECU (sliding roof drive gear sub-assembly) and main body ECU (instrument panel junction block)/OK or Stop | OK: Connected Stop: Not connected | DTC is output if an error occurs in LIN communication |
| Communication Master SW*1 | Connection status between power window regulator master switch assembly and main body ECU (instrument panel junction block)/OK or Stop | OK: Connected Stop: Not connected | DTC is output if an error occurs in LIN communication |