Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › LIN COMMUNICATION SYSTEM

DTC    B2287    LIN Communication Master Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when there is an open, short or ECU communication malfunction between the main body ECU (instrument panel junction block) and certification ECU (smart key ECU assembly).

DTC Code
DTC Detection Condition
Trouble Area
B2287
There is an open, short or ECU communication malfunction between the main body ECU (instrument panel junction block) and certification ECU (smart key ECU assembly).
  1. Main body ECU (Instrument panel junction block)
  2. Certification ECU (Smart key ECU assembly)
  3. Wire harness or connector

WIRING DIAGRAM


B203745E11


INSPECTION PROCEDURE

NOTICE:
  1. If the certification ECU (smart key ECU assembly) is replaced, register the key.
  2. When using the intelligent tester to troubleshoot with the engine switch off:
    Connect the intelligent tester to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the intelligent tester and vehicle begins.

1.CHECK DTC OUTPUT
  1. Clear the DTC (Click here).

  1. Recheck for DTCs.

    HINT:
    Check the both Entry & Start and Main Body DTCs.

    Result:
    Result
    Proceed to
    Only DTC B2287 is output.
    A
    DTC B2287 and B2785 are output simultaneously.
    B

    HINT:
    When DTC B2287 and B2785 are output simultaneously, perform troubleshooting for DTC B2785 first.



B
GO TO DTC B2785 (Click here)
A


2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - MAIN BODY ECU)
  1. Disconnect the IR junction block connector.



    B222210E01
  1. Disconnect the E74 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E74-10 (LIN) - IR-9 (LIN1)
    Always
    Below 1 Ω
    E74-10 (LIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
  1. Replace the main body ECU (instrument panel junction block).


NEXT


4.CHECK DTC OUTPUT
  1. Clear the DTC (Click here).

  1. Recheck for DTCs.

    OK:
    DTC B2287 is not output.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END (MAIN BODY ECU WAS DEFECTIVE)