DTC B2786 No Response from Steering Lock ECU |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2786 | No communication between the steering lock ECU (steering lock actuator assembly) and certification ECU (smart key ECU assembly) for more than 10 seconds. |
|

| 1.CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the E69 ECU connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E69-1 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| E69-7 (B) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - STEERING LOCK ECU) |
![]() |
Disconnect the E74 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E74-10 (LIN) - E69-5 (LIN) | Always | Below 1 Ω |
| E74-10 (LIN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) |
Replace the steering lock ECU (steering lock actuator assembly) (Click here).
| NEXT | |
| 4.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||