DTC B2321 Driver Side Door ECU Communication Stop |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2321 | No communication between power window regulator motor (Driver side) and main body ECU (instrument panel junction block) for more than 10 seconds |
|

| 1.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 2.CHECK DTC OUTPUT |
Recheck for DTC (Click here).
| Result | Proceed to |
| B2321 is output | A |
| B2321 is not output | B |
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - POWER WINDOW REGULATOR MOTOR) |
Disconnect the E8 and I5*1 or H10*2 connectors.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E8-10 (LIN2) - I5-9 (LIN)*1 E8-10 (LIN2) - H10-9 (LIN)*2 | Always | Below 1 Ω |
| E8-10 (LIN2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MOTOR - BATTERY AND BODY GROUND) |
![]() |
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I5-1 (E) - Body ground*1 H10-1 (E) - Body ground*2 | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| I5-2 (B) - Body ground*1 H10-2 (B) - Body ground*2 | Always | 11 to 14 V |
|
| ||||
| OK | |
| 5.REPLACE POWER WINDOW REGULATOR MOTOR (DRIVER SIDE) |
Replace the power window regulator motor (Driver side) (Click here).
| NEXT | |
| 6.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Recheck for DTC.
| Result | Proceed to |
| B2321 is not output | A |
| B2321 is output | B |
|
| ||||
| A | ||
| ||