Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › LIN COMMUNICATION SYSTEM

DTC    B2789    No Response from ID BOX

for Preparation Click here


DESCRIPTION

This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) stops for more than 10 seconds.

DTC Code
DTC Detection Condition
Trouble Area
B2789
No communication between the certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) for more than 10 seconds.
  1. ID code box (Immobiliser code ECU)
  2. Certification ECU (Smart key ECU assembly)
  3. Wire harness or connector

WIRING DIAGRAM


B203744E59


INSPECTION PROCEDURE

NOTICE:
  1. If the certification ECU (smart key ECU assembly) is replaced, register the key.
  2. If the ID code box (immobiliser code ECU) is replaced, register the ECU code and ECU communication ID.
  3. When using the intelligent tester to troubleshoot with the engine switch off:
    Connect the intelligent tester to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the intelligent tester and vehicle begins.

1.CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY AND BODY GROUND)


    B164449E17
  1. Disconnect the E68 ECU connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E68-8 (GND) - Body ground
    Always
    Below 1 Ω

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E68-1 (+B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ID CODE BOX)


    B190857E03
  1. Disconnect the E74 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E74-10 (LIN) - E68-3 (LIN1)
    Always
    Below 1 Ω
    E74-10 (LIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE ID CODE BOX (IMMOBILISER CODE ECU)
  1. Replace the ID code box (immobiliser code ECU).


NEXT


4.CHECK DTC OUTPUT
  1. Clear the DTC (Click here).

  1. Recheck for DTCs.

    OK:
    DTC B2789 is not output.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END (ID CODE BOX (IMMOBILISER CODE ECU) WAS DEFECTIVE)