NAVIGATION SYSTEM > PRECAUTION |
| 1.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2.EXPRESSIONS OF IGNITION SWITCH |
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Switch Type | Ignition Switch (Position) | Engine Switch (Condition) | |
| Expression | Ignition Switch off | LOCK | Off |
| Ignition Switch ON | ON | On (IG) | |
| Ignition Switch ACC | ACC | On (ACC) | |
| Engine Start | START | Start | |
| 3.PRECAUTIONS FOR HARD DISK DRIVE (HDD) |
An HDD is built into the navigation receiver assembly to store map data etc. which will be used for the navigation system (for HDD). Therefore, care must be taken for the following points when handling:
Do not apply any vibration or shock to the display and navigation module.
Do not remove the display and navigation module if there is a risk that condensation may occur.
Take measures to prevent static electricity.
Keep the navigation receiver assembly away from magnets or magnetized items.