TOYOTA PARKING ASSIST-SENSOR SYSTEM > CUSTOMIZE PARAMETERS |
| CUSTOMIZE PARAMETERS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Clearance Sonar / Utility / Customize Setting.
Select the setting by referring to the table below.
| Display | Default | Content | Setting |
| Rr Sensor Onset Range | Wide | Set the buzzer activation range for the rear center sensors. | Narrow or Wide
|
| Keep Sense Buzzer | Avail | Make the buzzer sound when the distance between the vehicle and obstacle does not change for more than 3 seconds. | Not Avail or Avail
|
| Fr & Rr Buzzer Volume | H | Change the buzzer volume setting. | L, M1, M2, M3 or H
|
| Display | Default | Content | Setting |
| Sensor Condition N | Avail | Make the front sensors available when the shift lever is in N. | Not Avail or Avail
|
| Reverse Range Front Sensor | F | Change the operation setting for the front sensors when the shift lever is in R. | F or F Stop
|
| Non P/R Range Rear Sensor | R Stop | Change the operation setting for the rear sensors when the shift lever is in any position except P or R. | R, Rcrn or R Stop
|