Home › BODY ELECTRICAL › DOOR LOCK › DOOR CONTROL RECEIVER (for Rear Side)

DOOR CONTROL RECEIVER (for Rear Side) > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT CUSHION ASSEMBLY
for Fold Down Seat Type:
for Reclining Seat Type:


2. REMOVE REAR SEAT HEADREST ASSEMBLY (for Reclining Seat Type)
  1. Remove the 2 rear seat headrest assemblies.



3. REMOVE REAR SEAT BACK COVER (for Reclining Seat Type)


    B139075
  1. Using a screwdriver, detach the claws and remove the 2 rear seatback covers.

    NOTICE:
    1. Tape the screwdriver tip before use.
    2. Use the same procedures for the RH side and LH side.



4. REMOVE SEPARATE TYPE REAR SEATBACK ASSEMBLY RH (for Reclining Seat Type)


    B139078E01
  1. Separate the rear seat belt.



    B139082E01
  1. Disengage the 3 clamps and then separate the cover.



    B139079
  1. Remove the 2 bolts and 2 nuts and separate type rear seatback assembly RH.



5. REMOVE REAR SIDE SEAT BACK ASSEMBLY RH (for Fold Down Seat Type)

HINT:
Use the same procedure for the RH side and LH side .



6. REMOVE RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY RH (for Reclining Seat Type)

HINT:
Use the same procedure for the RH side and LH side .



7. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and LH side .



8. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH


9. REMOVE ROOF SIDE INNER GARNISH RH

HINT:
Use the same procedure for the RH side and LH side .



10. REMOVE DOOR CONTROL RECEIVER


    B223345
  1. Disconnect the connector.

  1. Remove the bolt and door control receiver.