Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › CLEARANCE WARNING BUZZER (for Back Sensor)

CLEARANCE WARNING BUZZER (for Back Sensor) > INSPECTION

for Preparation Click here



1. INSPECT CLEARANCE WARNING BUZZER


    E159910E02
  1. Apply battery voltage and check operation of the warning buzzer, as shown in the table below.

    Result:
    Measurement Condition
    Specified Condition
    Battery voltage (+) → 1
    Battery voltage (-) → 2
    Operating sound occurs

    If the result is not as specified, replace the clearance warning buzzer.

    HINT:
    The clearance warning buzzer does not sound without battery voltage applied because the buzzer is a separately-excited type.