Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Front Clearance Sonar Sensor RH Circuit

for Preparation Click here


DESCRIPTION

The No. 1 ultrasonic sensor (front right sensor) is installed on the front bumper.
The clearance warning ECU detects obstacles based on signals received from the front right sensor. If the front right sensor circuit has an open, short or other malfunction, it will not function normally.

WIRING DIAGRAM


E159947E04


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - FRONT RIGHT SENSOR)


    E159931E02
  1. Disconnect the S17 connector from the clearance warning ECU.

  1. Disconnect the i2 connector from the No. 1 ultrasonic sensor (front right sensor).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S17-31 (L1) - i2-1 (S)
    Always
    Below 1 Ω
    S17-32 (L2) - i2-2 (E)
    Always
    Below 1 Ω
    S17-31 (L1) - Body ground
    Always
    10 kΩ or higher
    S17-32 (L2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT NO. 1 ULTRASONIC SENSOR (FRONT RIGHT SENSOR)


    E159935E02
  1. Remove the No. 1 ultrasonic sensor (front right sensor) (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (S) - 2 (E)
    Always
    8 to 12 kΩ



NG
REPLACE NO. 1 ULTRASONIC SENSOR (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)