Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Parking Brake Switch Circuit

for Preparation Click here


DESCRIPTION

The parking brake switch assembly turns on and off according to the operation of the parking brake lever (for M/T) or parking brake pedal (for A/T).
The clearance warning ECU stops detection operation when it receives an on signal from the parking brake switch.

WIRING DIAGRAM


E159913E01


INSPECTION PROCEDURE

1.CONFIRM MODEL
  1. Choose the model to be inspected.

    Result:
    Model
    Proceed to
    for Foot Pedal Type
    A
    for Lever Type
    B



B
Go to step 4
A


2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - PARKING BRAKE SWITCH ASSEMBLY)


    E159921E01
  1. Disconnect the S17 connector from the clearance warning ECU.

  1. Disconnect the A18 connector from the parking brake switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S17-2 (P1) - A18-1
    Always
    Below 1 Ω
    S17-2 (P1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT PARKING BRAKE SWITCH ASSEMBLY


    E159907E01
  1. Remove the parking brake switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    Switch connector (A) - Switch body (B)
    ON (When shaft is not pressed)
    Below 1 Ω
    Switch connector (A) - Switch body (B)
    OFF (When shaft is pressed)
    10 kΩ or higher



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

4.CHECK HARNESS AND CONNECTOR


    E159921E04
  1. Disconnect the S17 connector from the clearance warning ECU.

  1. Disconnect the E33 connector from the parking brake switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S17-2 (P1) - E33-1
    Always
    Below 1 Ω
    S17-2 (P1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT PARKING BRAKE SWITCH ASSEMBLY


    E159906E01
  1. Remove the parking brake switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    Switch connector (A) - Switch body (B)
    ON (When shaft is not pressed)
    Below 1 Ω
    Switch connector (A) - Switch body (B)
    OFF (When shaft is pressed)
    10 kΩ or higher



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)