DTC C1439/66 Steering Angle Sensor Initialization Incomplete |
DTC C1445/66 Vehicle Driven with Steering Angle Sensor not Initialized |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1439/66 | After the steering angle sensor zero point calibration is cleared due to, for example, fluctuations in the power source, the steering angle sensor zero point calibration cannot be obtained for 60 seconds of continuous driving. |
|
| C1445/66 | Steering angle sensor zero point calibration cannot be obtained when the vehicle is driven without a record of steering angle sensor zero point calibration at a speed of 35 km/h (22 mph) or more for 30 seconds or more without the brake pedal being depressed. |
|
| 1.CHECK DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch on (IG) again and check that no CAN communication system DTCs are output.
Drive the vehicle and turn the steering wheel to the right and left at a speed of 35 km/h (22 mph) and check that no speed sensor, yaw rate and acceleration sensor and steering angle sensor DTCs are output (Click here).
| Result | Proceed to |
| DTCs (C1439/66 and/or C1445/66) are output | A |
| CAN communication system DTC is output | B |
| Speed sensor, yaw rate and acceleration sensor and/or steering angle sensor DTC is output | C |
| DTCs (C1439/66 and C1445/66) are not output | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION |
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.
Check if the centered position of the steering wheel is correctly set while driving straight ahead.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle and turn the steering wheel to the right and left at the speed of 35 km/h (22 mph) or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTCs (C1439/66 and C1445/66) are not output | A |
| Yaw rate and acceleration sensor and/or steering angle sensor DTC is output | B |
|
| ||||
| A | ||
| ||