Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
NM19V0EQ _58 Vehicle Interior _014277 HEATING / AIR CONDITIONING _0072887 AIR CONDITIONING SYSTEM GE GENERAL F

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

Both manual and automatic air conditioning systems are available.


b.

The automatic air conditioning system uses left and right independent temperature control and neural network control to enhance comfort.



SPECIFICATION


a.

Performance

Heater Heater Output W 5850
Air Flow Volume m3/h 380
Power Consumption W 220
Cooler Cooling Capacity W 6100
Air Flow Volume m3/h 530
Power Consumption W 260


b.

Ventilation and Heater Core

Heater Radiator Unit Sub-assembly Type Straight Flow Aluminum (SFA) -II
Size W x H x L mm (in.) 201.5 x 150 x 27 (7.9 x 5.9 x 1.1)
Fin Pitch mm (in.) 1.5 (0.06)
Blower with Fan Motor Sub-assembly Motor Type BMM - K70
Fan Type Semi Sirocco
Fan Size (Dia. x H) mm (in.) 165 x 70 (6.5 x 2.8)


c.

Air Conditioning

Cooler Condenser Assembly Type Multi-Flow (MF)-IV
Size W x H x L mm (in.) 720 x 370.2 x 16
(28.3 x 14.6 x 0.6)
Fin Pitch mm (in.) 3.15 (0.12)
Compressor with Pulley Assembly Type TSE17C
Pulley Plastic Damper and Limiter (DL)
Oil Volume cc 100 to 115
Refrigerant Type HFC 134a
Charge Volume g 450 to 550
Evaporator Type Revolutionary super-slim Structure (RS)
Size W x H x L mm (in.) 266.3 x 251 x 38 (10.5 x 9.9 x 1.5)
Fin Pitch mm (in.) 2.6 (0.10)



MAIN FEATURES


a.

The air conditioning system has the following features:

High Performance Manual and Automatic
·

Using the following features of the compressor with pulley assembly (continuously variable capacity compressor), high cooling performance and a quiet cabin have been achieved:

·

Magnetic Flux Sensor Type Air Conditioning Mass Flow Sensor

·

Oil Separator

·

Variable Suction Side Throttle

·

Solenoid Valve with Built-in Crank Chamber to Suction Passage (CS) Valve



Automatic
·

Neural network control is used so passengers can finely control the air conditioning for maximum comfort.

·

The blower control has 7 steps to allow precise control.


Lightweight Manual and Automatic
·

An air conditioning harness assembly with a built-in IC is used in a lightweight wire harness design to allow a reduced number of wires.

·

The use of this connector means that pulse pattern type servo motors are used.


Others Manual and Automatic The following parts are used to ensure high cooling performance while realizing a compact and lightweight construction.
·

Semi-center Location Air Conditioning Unit

·

Revolutionary Super-slim Structure (RS) Evaporator

·

Straight Flow Aluminum (SFA)-II Heater Radiator Sub-assembly

·

Multi-Flow (MF)-IV Sub-cool Condenser