Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › SFI SYSTEM
NM19V0EQ _51 Engine / Hybrid System _014243 2AR-FE ENGINE CONTROL _0072842 SFI SYSTEM DE DETAILS F

2AR-FE ENGINE CONTROL  SFI SYSTEM  DETAILS  THROTTLE POSITION SENSOR  


CONSTRUCTION


a.

This non-contact type throttle position sensor uses a Hall IC, which is mounted on the throttle body with motor assembly.

i.

The Hall IC is surrounded by a magnetic yoke. The Hall IC converts the changes that occur in the magnetic flux into electrical signals, and outputs them in the form of throttle valve position signals to the ECM.


ii.

The Hall IC contains circuits for the main and sub signals. It converts the throttle valve opening angle into electric signals that have differing characteristics, and outputs them to the ECM.

W105173
5.146,1.76 5.802,1.76 true 1.281,5.719 1.083,5.719 1.083,5.719 1.083,6.115 true 5.156,1.938 5.156,2.688 true 5.74,0.521 5.604,0.521 5.604,0.521 5.198,1.573 true 5.854,1.677 6.313,1.865 0.458,0.188 10 Hall IC 4.927,2.719 5.448,2.906 0.521,0.188 10 Magnet 4.365,4.094 4.594,4.26 0.229,0.167 10 (V) 0.49,3.635 2.031,3.781 1.542,0.146 10 Throttle Position Sensor 2.188,4.729 2.552,4.927 0.365,0.198 10 VTA 2.24,5.073 2.49,5.271 0.25,0.198 10 E2 2.229,5.396 2.458,5.594 0.229,0.198 10 VC 2.167,5.698 2.531,5.896 0.365,0.198 10 VTA2 4.635,4.448 5,4.646 0.365,0.198 10 VTA2 2.938,5.094 3.292,5.271 0.354,0.177 10 ECM 5.76,5.021 6.125,5.219 0.365,0.198 10 VTA 3.948,4.927 4.448,5.354 0.5,0.427 10 Output Voltage 4.323,4.323 4.448,4.552 0.125,0.229 10 5 4.323,5.448 4.448,5.677 0.125,0.229 10 0 4.083,5.823 4.865,6.01 0.781,0.188 10 Fully Closed 6.344,5.823 7.052,6.01 0.708,0.188 10 Fully Open 6.708,5.552 7.021,5.74 0.313,0.188 10 90° 4.76,6.208 6.604,6.385 1.844,0.177 10 Throttle Valve Opening Angle 5.771,0.458 6.375,0.906 0.604,0.448 10 Magnetic Yoke 4.333,3.438 5.875,3.583 1.542,0.146 10 Throttle Position Sensor 0.875,6.125 1.396,6.313 0.521,0.188 10 Magnet

HINT:

The inspection method differs from a contact type throttle position sensor because this non-contact type throttle position sensor uses a Hall IC. For details, refer to the Repair Manual.