Home › Engine / Hybrid System › 2AR-FE ENGINE MECHANICAL › ENGINE UNIT
NM19V0EQ _51 Engine / Hybrid System _014244 2AR-FE ENGINE MECHANICAL _0072843 ENGINE UNIT DE DETAILS F

2AR-FE ENGINE MECHANICAL  ENGINE UNIT  DETAILS  CRANKSHAFT BEARING  


CONSTRUCTION


a.

The crankshaft bearings are reduced in width to reduce friction.


b.

The lining surfaces of the crankshaft bearings are micro-grooved to achieve an optimal amount of oil clearance. As a result, cold-engine cranking performance has been improved and engine vibration has been reduced.


c.

The oil groove on the crankshaft bearing is made eccentric to reduce the amount of oil leakage from the bearing. This enables the capacity of the oil pump to be reduced in order to reduce parasitic losses.

W100800
3.146,0.906 3.146,0.188 3.146,0.188 3.25,0.188 true 2.792,1.073 2.333,0.615 2.333,0.615 2.135,0.615 true 3.323,1.948 3.323,2.344 true 2.427,4.229 2.427,4.604 true 5.125,4.208 5.125,4.563 true 3.292,0.104 4.042,0.458 0.75,0.354 10 *1 1.958,0.531 2.667,0.719 0.708,0.188 10 *a 1.802,1.969 2.719,2.125 0.917,0.156 10 *b 3.271,2.385 3.469,2.563 0.198,0.177 10 *2 4.531,1.146 4.708,1.302 0.177,0.156 10 *e 4.188,1.375 4.552,1.531 0.365,0.156 10 *d 4.896,1.365 5.083,1.521 0.188,0.156 10 *d 2.396,4.625 2.573,4.781 0.177,0.156 10 *f 2.469,5.25 2.667,5.396 0.198,0.146 10 *h 4.51,1.823 4.729,2.01 0.219,0.188 10 *c 5.063,4.573 5.281,4.938 0.219,0.365 10 *g 5.271,5.24 5.438,5.406 0.167,0.167 10 *i
*1 Upper Main Bearing *2 Lower Main Bearing
*a Oil Groove *b Micro-grooved
*c Oil Groove Depth *d Edge
*e Center *f Large amount of oil leakage at end of groove
*g Smaller amount of oil leakage at end of groove *h Conventional Oil Groove
*i Off-center Oil Groove - -