CONSTRUCTION
The hydraulic lash adjusters, which are located at the fulcrum (pivot point) of the No. 1 valve rocker arm sub-assemblies, each consists primarily of a plunger, plunger spring, check ball, and check ball spring.
Both the engine oil that is supplied by the cylinder head and the built-in spring actuate the valve lash adjuster assemblies. The oil pressure and the spring force that act on the plunger push the No. 1 valve rocker arm sub-assemblies against the cam in order to adjust the clearance between the valve stem and the No. 1 valve rocker arm sub-assembly. This prevents the generation of noise during the opening and closing of the valves. As a result, engine noise is reduced.
| *1 | No. 1 Valve Rocker Arm Sub-assembly | *2 | Cam |
| *3 | Oil Passage | *4 | Valve Lash Adjuster Assembly |
| *5 | Plunger | *6 | Check Ball |
| *7 | Check Ball Spring | *8 | Plunger Spring |