Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › 2011.10–2015.04
NM19V0EQ _56 Audio / Visual / Telematics _014269 PARK ASSIST / MONITORING _0072871 TOYOTA PARKING ASSIST-SENSOR SYSTEM CO CONTROL F

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  CONTROL  TOYOTA PARKING ASSIST-SENSOR CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Function
Clearance Warning ECU Assembly
·

Judges the approximate distance between the vehicle and an obstacle based on signals from the No. 1 ultrasonic sensors.

·

Sounds the No. 1 clearance warning buzzer.


No. 1 Ultrasonic Sensor (2) Detects the distance between the vehicle and an obstacle.
No. 1 Clearance Warning Buzzer Sounds to inform the driver according to the distance to the obstacle.
Back Sonar or Clearance Sonar Switch Assembly Operating this switch allows the operation of toyota parking assist-sensor system to be enabled or disabled.
Park/Neutral Position Switch Assembly Sends the shift position signals to the Clearance Warning ECU Assembly.


SYSTEM CONTROL


a.

Detection Area

i.

The detection area of the No. 1 ultrasonic sensor is as shown in the following illustration.


ii.

This detection area is applicable when positioning a 60 mm (2.36 in.) diameter pole parallel or perpendicular to the ground. The ranges vary depending on the measuring method and type of obstacle.

Y113047
5.802,1.135 6.083,1.375 0.281,0.24 10 false *a 4.146,2.083 4.448,2.365 0.302,0.281 10 false *b 4.833,2.427 5.125,2.688 0.292,0.26 10 false *c 5.76,3.563 6.01,3.844 0.25,0.281 10 false *d 4.146,4.406 4.396,4.635 0.25,0.229 10 false *b
*a Approximately 1800 mm (70.9 in.) *b Approximately 200 mm (7.9 in.)
*c Approximately 1000 mm (39.4 in.) *d Approximately 500 mm (19.7 in.)




b.

The operating condition of the sensor is as follows:

Installation Position Operating Condition
Rear Center
·

Ignition switch is ON.

·

System is activated.

·

Shift lever is in R.