Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › 2011.10–2015.04
NM19V0EQ _57 Power Source / Network _014270 NETWORKING _0072876 CAN COMMUNICATION SYSTEM CO CONTROL F

NETWORKING  CAN COMMUNICATION SYSTEM  CONTROL  CAN COMMUNICATION CONTROL  


DIAGNOSIS


a.

If a malfunction occurs on a CAN communication bus, ECUs that are connected to the CAN communication bus store a Diagnostic Trouble Code (DTC) in memory.


b.

The 5-digit DTCs can be read after connecting the intelligent tester to the DLC3.


c.

The DLC3 is equipped with a CAN-H and a CAN-L terminal on the V bus to allow CAN diagnosis. It is possible to determine if there is an open or short in the main wires of the V bus by measuring the resistance value between these terminals.


d.

For details, refer to the Repair Manual.