OPERATION
The combination meter assembly has a cruise control indicator (constant speed control mode), cruise control indicator (vehicle-to-vehicle distance control mode), cruise control SET indicator, buzzer, and multi-information display to provide warnings and messages regarding the dynamic radar cruise control system.
The multi-information display displays the set vehicle speed, vehicle ahead mark, and warning message.
Examples are shown below for the illumination or display of each indicator or multi-information display.
| Condition | Multi-information Display*1 | Buzzer |
|---|---|---|
|
*1: These illustrations are examples. *2: While driving at a set speed of 100 km/h (62 mph). |
||
| Being Controlled*2 |
|
- |
| System Check |
|
Buzzer in the combination meter assembly sounds once |
| Condition | Multi-information Display*1 | Buzzer |
|---|---|---|
|
*1: These illustrations are examples. *2: While driving at a set speed of 100 km/h (62 mph). |
||
| Set Standby |
|
- |
| Under Constant Speed Control (No Vehicle Ahead, Long)*2 |
|
- |
| Under Follow-up Control (Vehicle Ahead, Middle)*2 |
|
- |
| Deceleration Control/Vehicle Approach Warning (Vehicle Ahead, Long)*2 |
|
Skid control buzzer sounds continuously |
| Blinks | ||
| Millimeter Wave Radar Sensor Assembly is Dirty. |
|
Buzzer in the combination meter assembly sounds once |
| Poor Weather Conditions |
|
Buzzer in the combination meter assembly sounds once |
| System Check |
|
Buzzer in the combination meter assembly sounds once |
| Beam Axis Adjustment |
|
Skid control buzzer sounds once |