Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2015.04
NM19V0EQ _58 Vehicle Interior _036069 PRE-CRASH SAFETY _0166627 PRE-CRASH SAFETY SYSTEM DE DETAILS F

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  DETAILS  INDICATOR LIGHT/WARNING LIGHT/MULTI DISPLAY  


FUNCTION


a.

Warning Indication

i.

The combination meter assembly uses the multi-information display, master warning light, PCS warning light and buzzer to provide the driver with pre-crash safety system warnings and indications.


ii.

If the driving support ECU assembly determines that the possibility of a collision is high, it sends a signal to the combination meter assembly. Upon receiving this signal, the combination meter assembly indicates a warning using the multi-information display and skid control buzzer assembly. Details are indicated below.

When there is a high possibility of a collision
Multi-information Display Skid Control Buzzer Assembly
BRAKE! Sounds Continuously


iii.

When the system is not available, the following warning occurs to warn the driver.

When a system malfunction is detected
Multi-information Display Detail Master Warning Light PCS Warning Light Buzzer DTC
Check
Pre-Crash Safety
This message appears when the driving support ECU assembly detects a system malfunction. Illuminates Flashes Sounds once Repair is required Corresponding
DTCs are stored
Pre-Crash Safety temporarily
not available
This message appears when the driving support ECU assembly determines either of the following conditions is present:
·

Dirty millimeter wave radar sensor assembly

·

Poor weather conditions


After these conditions have been resolved, the system will operate normally.
- Flashes - -

When the pre-crash safety system has been disabled using the pre-crash system switch assembly (pre-crash system cancel switch assembly)
Multi-information Display Detail Master Warning Light PCS Warning Light Buzzer
Pre-Crash Safety Off
·

This message appears for 6 seconds on the multi-information display.

·

The pre-crash safety system has been disabled. If the switch is pressed again, the system will resume.


- Illuminates -

When the VSC OFF switch is pressed
Multi-information Display Detail Master Warning Light PCS Warning Light Buzzer
Pre-Crash Brake is Disabled Due to VSC Off
·

This message appears for 6 seconds on the multi-information display.

·

Pre-crash brake and pre-crash brake assist operation is disabled (the warning for when there is a high possibility of a collision is still enabled).


- Illuminates -