Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › 2015.04–2016.05
NM19V0EQ _56 Audio / Visual / Telematics _014269 PARK ASSIST / MONITORING _0072871 TOYOTA PARKING ASSIST-SENSOR SYSTEM GE GENERAL F

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

The TOYOTA parking assist-sensor systems shown below are provided:

Type No. 1 Ultrasonic Sensor Information
Corners Rear Multi-information Display Multi-display No. 1 Clearance Warning Buzzer

○: Equipped

-: Not equipped

2-sensor - ○ - - ○
4-sensor ○ - ○ ○ ○


b.

The TOYOTA parking assist-sensor system uses No. 1 ultrasonic sensors to detect obstacles at the corners*1 or the rear*2 of the vehicle.

*1: 4-sensor type

*2: 2-sensor type


c.

The TOYOTA parking assist-sensor system informs the driver of the approximate distance between the No. 1 ultrasonic sensors and any obstacles as well as their positions by displaying them on the multi-information display in the combination meter assembly* and navigation receiver assembly* and by sounding the No. 1 clearance warning buzzer.

*: 4-sensor type



PRECAUTION


a.

The detection function of the TOYOTA parking assist-sensor system may not operate properly in the following conditions:

i.

When foreign matter such as ice, snow or mud is attached to the No. 1 ultrasonic sensors. If the sensor is cleaned, the system will return to normal.


ii.

When a No. 1 ultrasonic sensor is frozen. If the No. 1 ultrasonic sensor temperature rises, the system will return to normal.


iii.

When a No. 1 ultrasonic sensor is covered with something. If the object is removed, the system will return to normal.



b.

Especially in cold weather, a malfunction warning may occur (the buzzer may sound) due to a frozen No. 1 ultrasonic sensor. If the malfunction warning occurs, be sure to check the No. 1 ultrasonic sensors. If there is no mud, ice or snow on the No. 1 ultrasonic sensors, a No. 1 ultrasonic sensor may be malfunctioning.


c.

In the following conditions, the detection range may be affected:

i.

Foreign matter such as snow or mud is attached to a No. 1 ultrasonic sensor.


ii.

When the vehicle is operated under the hot sun or in a freezing climate.



d.

The system may improperly detect obstacles in the following conditions:

i.

When the vehicle is being driven on bumpy road, gravel road, or on grass.


ii.

When the ultrasonic waves are received from the horn or parking sonar system of another vehicle, a motorcycle engine, or the air brakes of a large vehicle.


iii.

When there is a downpour, or water is splashing on the vehicle.


iv.

When the vehicle posture tilts significantly.


v.

When an antenna for a wireless transmitter is mounted on the vehicle.


vi.

When the No. 1 ultrasonic sensors are covered with foreign matter such as ice, snow or mud.


vii.

When the vehicle travels alongside a tall curb or a square curb.


viii.

When other vehicles with sonar are near.


ix.

When a towing hitch is mounted on the vehicle.


x.

When the bumper is damaged.



e.

There are cases in which the objects listed below cannot be detected:

i.

Thin objects such as wire or rope.


ii.

Objects with surfaces that are too small to reflect ultrasonic waves such as wire gauze or a fence.


iii.

Objects that absorb ultrasonic waves such as cotton or snow.


iv.

Objects that have sharp edges.


v.

Objects that are short.


vi.

Objects that are tall and protrude toward the vehicle above the detection range of the sensors.



f.

Other notices

i.

Objects directly underneath the bumpers cannot be detected. Some objects located lower than the No. 1 ultrasonic sensors, or thin objects, may not be detected as the vehicle approaches the objects.


ii.

An object might not be detected if the vehicle is too close.


iii.

The No. 1 ultrasonic sensors might not detect obstacles properly if they are exposed to strong shocks such as when being struck or dropped.