FUNCTION
Combination Meter Assembly
Buzzer Function
The table below shows the warning and reminder functions of the buzzer in the combination meter assembly.
|
*1: Models for G.C.C. countries *2: Models for Australia *3: Models with lane departure alert system *4: Models with smart entry and start system *5: Models with multi-information display *6: Models with dynamic radar cruise control system *7: Models with sliding roof system *8: Models without multi-information display |
|||
| 1 | Driver Side Seat Belt Warning (5 Times at the Maximum)*1 | 2 | Driver Side Seat Belt Warning (Once)*1 |
| 3 | Front Passenger Side Seat Belt Warning (Once)*1 | 4 | Seat Belt Warning (Level 2) |
| 5 | Seat Belt Warning (Level 1)*1 | 6 | Rear Passenger Side Seat Belt Warning*2 |
| 7 | Seat Belt Warning (Level 1)*2 | 8 | EPS Warning |
| 9 | Lane Departure Alert Warning*3 | 10 | Smart Entry and System Warning (Continuous)*4 |
| 11 | Smart Entry and start System Warning (Intermittent)*4 | 12 | Key Reminder Indicating Buzzer |
| 13 | Smart Entry and Start System Warning (Continuous, 9 Times at the Maximum)*4 | 14 | Smart Entry and Start System Warning (Once)*4 |
| 15 | Multi-information System Warning*5 | 16 | Dynamic Radar Cruise Control System Cancellation due to Low Speed Warning*6 |
| 17 | Immobiliser Certification Reminder | 18 | Speed Warning*1 |
| 19 | Parking Brake Engaged Warning | 20 | Door Open while Driving Warning |
| 21 | Sport Shift Reject Warning | 22 | Sliding Roof Open Warning*7,*8 |
| 23 | Turn Signal/Hazard Warning Operation | - | - |
LCD (Models without Multi-information Display)
Display Function Flow
The wide type LCD display changes in the following order due to ODO/TRIP switch and rheostat switch operation.
| *1 | Odometer | *2 | Trip Meter A |
| *3 | Trip Meter B | *4 | Ambient Temperature |
| *5 | Cruising Range | *6 | Total Average Fuel Consumption between Reset Operations |
| *7 | Current Fuel Consumption | *8 | Average Vehicle Speed after Engine Start-up |
| *9 | Meter Illumination Adjustment Mode | *10 | Eco Driving Indicator Light ON/OFF Mode |
|
ODO/TRIP switch pressed briefly. |
|
ODO/TRIP switch pressed and held. |
|
Rheostat switch pressed. | - | - |
Multi-information Display (Models with Multi-information Display)
Display Function Flow
The multi-information display can be switched as shown in the flow chart below:
| No. | Display Change Condition |
|---|---|
| *a | Conditions are met. |
| *b | Conditions are not met. |
| *c | If there are multiple display requests, items will be displayed in sequence. |
| *d | An item or display is selected by operating the steering pad switch assembly. |
| *e | After engine switch on (IG). |
| *f | The Eco Drive Level (ending) display is displayed for a certain period of time after the engine switch is turned off. |
Information Display Tab Operation
The information currently displayed can be switched using the RIGHT (PAGE) switch of the steering pad switch assembly.
| *A | Models with Navigation System | - | |
| *1 | Steering Pad Switch Assembly | *2 | RIGHT (PAGE) Switch |
| *3 | Drive Information | *4 | Navigation Information |
| *5 | Cruise Control System / Dynamic Radar Cruise Control System Information | *6 | Warning Message |
| *7 | Settings | - | - |
| *a | The illustrations shown are examples only. | - | - |
|
RIGHT (PAGE) switch operation | - | - |
Drive Information Mode Function
The drive information tab shows vehicle information such as drivable range and fuel consumption.
The drive information display can be changed by using the UP/DOWN switch of the steering pad switch assembly.
| *1 | Steering Pad Switch Assembly | *2 | UP Switch |
| *3 | DOWN Switch | *4 | Drive Information 1 |
| *5 | Drive Information 2 | *6 | Drive Information 3 |
| *7 | Blank | - | - |
| *a | The illustrations shown are examples only. | - | - |
|
DOWN switch operation |
|
UP switch operation |
Setting Function
The items displayed on the multi-information display can be customized.
The following items can be selected on the information setting screen.
| Item | Available Setting |
|---|---|
|
*: Models with navigation system |
|
| Language | The language used on the multi-information display can be selected:
·
English (Default) ·
French ·
Spanish |
| Unit | The unit displayed on the multi-information display can be selected:
·
km (L/100 km) (Default) ·
km (km/L) |
| Drive Information 3 | 2 items can be selected among the following:
·
Total Average Vehicle Speed between Reset Operations (Default of lower area) ·
Average Vehicle Speed after Engine Start-up ·
Total Elapsed Time between Reset Operations ·
Elapsed Time after Engine Start-up ·
Cruising Range (Default of upper area) ·
Cruising Range after Engine Start-up ·
Total Cruising Range between Reset Operations ·
Blank |
| ECO Driving Indicator Light | The ECO Driving Indicator Light can be switched:
·
ON (Default) ·
OFF |
| Interruption Display | The following displays that appear as soon as the set conditions are met can be switched to ON (default) or OFF:
·
Turn-by-turn Navigation Display* ·
Incoming Telephone Display ·
Rheostat |
| Accent Color | The accent color can be changed:
·
Clear Blue (Default) ·
Clear Turquoise ·
Deep Orange ·
Radiant Orange |
| Initialization | The set items can be initialized. |
Warning Mode Function
When a warning is necessary, the warning display interrupts the current display on the multi-information display.
The master warning light may illuminate or blink and the buzzer in the combination meter assembly may sound depending on the item displayed on the multi-information display.
| Priority | Display | Master Warning Light | Buzzer |
|---|---|---|---|
|
*1: Models with lane departure alert system *2: Models with dynamic radar cruise control system *3: Models with pre-crash safety system *4: If the vehicle has reached a speed of 5 km/h (3 mph) *5: Models with automatic high beam system |
|||
| 1 | Adjusting LDA Camera*1 | - | - |
| Adjusting Front Radar Beam*2 | - | - | |
| Checking Cruise Control C/D*2 | - | - | |
| Checking Cruise Control Brake*2 | - | - | |
| BRAKE!*3 | - | - | |
| 2 | Lane departure alert warning reminder indicator (image display)*1 | - | - |
| Dynamic radar cruise control warning reminder indicator (image display)*2 | - | - | |
| 3 | Door open (while driving) (image display)*4 | Blinks | Sounds |
| Door open (image display) | - | - | |
| Clearance sonar detection (image display) | - | - | |
| Check Park Sonar System | Illuminates | - | |
| Clean Park Sonar | Illuminates | - | |
| 4 | Auto Power OFF to Conserve Battery | - | - |
| 5 | Release Parking Brake | Blinks | Sounds |
| Key not detected | Blinks | Sounds | |
| 6 | Charging System Malfunction
See Owner's Manual |
- | - |
| Clean Radar Sensor*2 | Illuminates | Sounds | |
| Cruise Control not available*2 | Illuminates | Sounds | |
| LDA not available*1 | Illuminates | Sounds | |
| Check Entry & Start System | Blinks | Sounds | |
| BSM not available | Illuminates | Sounds | |
| Check Cruise Control System | Illuminates | Sounds | |
| Check BSM System | Illuminates | Sounds | |
| Check LDA System*1 | Illuminates | Sounds | |
| Check PCS System*3 | Illuminates | Sounds | |
| Engine Oil Pressure Low | Illuminates | Sounds | |
| LDA System is Unavailable Below Approx. 50 km/h.*1 | - | - | |
| LDA System is Unavailable at this Speed*1 | - | - | |
| 7 | Lane departure alert indicator (image display)*1 | - | - |
| Dynamic radar cruise control indicator (image display)*2 | - | - | |
| Pre-crash safety system alert (image display)*3 | - | - | |
| Pre-crash Safety Turned Off*3 | - | - | |
| Turn Power OFF | Blinks | Sounds | |
| Key detected in vehicle | Blinks | Sounds | |
| Depress brake pedal, touch engine switch with key | Blinks | Sounds | |
| Depress brake pedal and push engine switch to start | Blinks | Sounds | |
| Shift to P position to start | Blinks | Sounds | |
| 8 | Steering Lock active | Blinks | Sounds |
| 9 | Key Battery Low | Illuminates | Sounds |
| Check Headlight System*5 | Illuminates | Sounds | |
| 10 | Fuel Low | - | - |
| TRC OFF | - | - | |
| Power ON | - | - | |
| Depress brake pedal and push engine switch to start | - | - | |
| Pre-Crash Brake is disabled due to VSC OFF*3 | - | - | |
| PCS temporarily not available*3 | - | - | |
OPERATION
Eco Driving Indicator Light Operation
Eco Driving Indicator Light can operate when all of the following conditions are met:
The ignition switch is ON and the engine is running.
The vehicle is being driven with the shift lever in D.
Temporary S mode is not selected.
The vehicle is at a speed of 130 km/h (81 mph) or below.
Eco Drive Level (Models with Multi-information Display)
The eco drive level changes among 5 levels to indicate the average fuel consumption and current fuel consumption.
After the engine switch is turned off, the eco drive level display appears for 3 seconds in the multi-information display. When the average fuel consumption is 7.7 L/100 km or less or 13 km/L or higher, the "EXCELLENT!" message flashes.
| Average Fuel Consumption Level | Multi-information Display |
|---|---|
| Level 0
(15 L/100 km or higher) |
|
| Level 1
(15 to 13 L/100 km) |
|
| Level 2
(13 to 11 L/100 km) |
|
| Level 3
(11 to 9 L/100 km) |
|
| Level 4
(9 to 7 L/100 km) |
|
| Level 5
(7 L/100 km or less) |
|
| EXCELLENT!
(7.7 L/100 km or less) |
|
| Average Fuel Consumption Level | Multi-information Display |
|---|---|
| Level 0
(5 km/L or less) |
|
| Level 1
(5 to 7.5 km/L) |
|
| Level 2
(7.5 to 10 km/L) |
|
| Level 3
(10 to 12.5 km/L) |
|
| Level 4
(12.5 to 15 km/L) |
|
| Level 5
(15 km/L or higher) |
|
| EXCELLENT!
(13 km/L or higher) |
|