CONSTRUCTION
In the front shock absorber assembly, a low-pressure N2 gas sealed type construction is used to suppress cavitations and a multi-leaf type linear control valve is also used to attain the linear damping force characteristics, offering both predictable stability and ride comfort.
A multi-leaf type digressive control valve is used to increase damping force at low piston speeds while reducing high speed damping force. This improves vehicle agility while maintaining good ride comfort.*
To prevent hazardous conditions, make sure to empty the gas from the shock absorber before discarding an N2 gas sealed shock absorber. For details, refer to the Repair Manual.
Since the multi-leaf type linear control valve has a laminate-structure backing valve, it enables the damping force to be generated at lower piston speeds, compared to a structure which generates the damping force with only the base valve when compression force is applied.
A rebound spring is used to reduce vehicle roll stability during cornering.*
The built-in rebound spring is designed to function with the suspension spring in order to restrain suspension extension during rebound.*
*: Models with 18 inch aluminum wheel
| *A | Models without 18 Inch Aluminum Wheel | *B | Models with 18 Inch Aluminum Wheel |
| *1 | Low-pressure N2 Gas | *2 | Base Valve |
| *3 | Multi-leaf Type Linear Control Valve | *4 | Multi-leaf Type Digressive Control Valve |
| *5 | Backing Valve | *6 | Inner Valve |
| *7 | Rebound Spring | - | - |
|
Oil Flow |
|
Compression Force |
The illustration below shows a comparison of multi-leaf type linear control valve, multi-leaf type digressive control valve and conventional valve damping force characteristics.