Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › from 2016.05
NM19V0EQ _57 Power Source / Network _014270 NETWORKING _0072876 CAN COMMUNICATION SYSTEM GE GENERAL F

NETWORKING  CAN COMMUNICATION SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

The Controller Area Network (CAN) uses 2 different types of CAN buses:

·

The CAN V bus, CAN sub bus 2 and CAN sub bus 13 are HS-CAN buses that operate at 500 kbps.

·

The CAN sub bus 1 is an MS-CAN bus that operates at 250 kbps.



b.

Each CAN bus has 2 terminating resistors which are necessary for accurate judgment of communication.


c.

The terminating resistors for each bus are located as shown in the following table.

Speed Communication Bus Terminating Resistor Location
High-speed (HS-CAN) CAN V Bus
·

ECM

·

Combination Meter Assembly


CAN Sub Bus 2
·

Network Gateway ECU

·

CAN No. 7 Junction Connector


CAN Sub Bus 13
·

Driving Support ECU Assembly

·

Millimeter Wave Radar Sensor Assembly


Middle-speed (MS-CAN) CAN Sub Bus 1
·

Main Body ECU (Multiplex Network Body ECU)

·

CAN No. 4 Junction Connector




d.

The network gateway ECU has a gateway function and is used to transmit data between the CAN V bus and the CAN sub bus 2.


e.

The main body ECU (multiplex network body ECU) has a gateway function and is used to transmit data between the CAN V bus and the CAN sub bus 1.