| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Camshaft bearing cap x Camshaft housing sub-assembly | 16 | 163 | 12 | ||||
| Camshaft housing sub-assembly x Cylinder head sub-assembly | 27 | 275 | 20 | ||||
| Camshaft timing gear assembly x Camshaft | 85 | 867 | 63 | ||||
| Camshaft timing exhaust gear assembly x No. 2 camshaft | 85 | 867 | 63 | ||||
| No. 1 chain tensioner assembly x Cylinder block sub-assembly | 10 | 102 | 7 | ||||
| Timing chain cover plate x Timing chain cover sub-assembly | 10 | 102 | 7 | ||||
| Engine wire x Engine | Nut A | 9.8 | 100 | 87 | |||
| Nut B | 8.0 | 82 | 71 | ||||
| Bolt | 8.0 | 82 | 71 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Cylinder head sub-assembly x Cylinder block sub-assembly | 1st | 36 | 367 | 27 | ||
| 2nd | 36 | 367 | 27 | |||
| 3rd | Turn 90° | |||||
| 4th | Turn 90° | |||||
| Camshaft bearing cap x Camshaft housing sub-assembly | 16 | 163 | 12 | |||
| Camshaft housing sub-assembly x Cylinder head sub-assembly | 27 | 275 | 20 | |||
| Camshaft timing gear assembly x Camshaft | 85 | 867 | 63 | |||
| Camshaft timing exhaust gear assembly x No. 2 camshaft | 85 | 867 | 63 | |||
| No. 1 chain vibration damper x Cylinder block sub-assembly | 21 | 214 | 15 | |||
| Chain tensioner slipper x Cylinder head sub-assembly | 21 | 214 | 15 | |||
| No. 1 chain tensioner assembly x Cylinder block sub-assembly | 10 | 102 | 7 | |||
| Timing chain guide x Camshaft housing sub-assembly | 21 | 214 | 15 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Stud bolt x Cylinder head sub-assembly | 6.5 | 66 | 58 | ||||
| No. 1 straight screw plug x Cylinder head sub-assembly | 44 | 449 | 32 | ||||
| No. 2 straight screw plug x Cylinder head sub-assembly | 78 | 795 | 58 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Stud bolt x Cylinder block sub-assembly | Stud bolt A | 6.5 | 66 | 58 | |||
| Stud bolt B | 8.5 | 87 | 75 | ||||
| No. 2 oil nozzle x Cylinder block sub-assembly | 10 | 102 | 7 | ||||
| No. 1 oil nozzle x Cylinder block sub-assembly | 10 | 102 | 7 | ||||
| Crankshaft bearing cap x Cylinder block sub-assembly | 1st | 20 | 204 | 15 | |||
| 2nd | 40 | 408 | 30 | ||||
| 3rd | Turn 90° | ||||||
| Connecting rod cap x Connecting rod sub-assembly | 1st | 40 | 408 | 30 | |||
| 2nd | Turn 90° | ||||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Crankshaft pulley x Crankshaft | 260 | 2651 | 192 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Flywheel sub-assembly x Crankshaft | 130 | 1326 | 96 | |||
| Drive plate and ring gear sub-assembly x Crankshaft | 98 | 999 | 72 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Engine mounting bracket RH x Cylinder block sub-assembly | 54 | 551 | 40 | ||||
| Engine mounting insulator LH x Front frame assembly | 87 | 887 | 64 | ||||
| Engine mounting insulator RH x Front frame assembly | 87 | 887 | 64 | ||||
| Front engine mounting insulator x Front frame assembly | 52 | 530 | 38 | ||||
| Engine mounting insulator LH x Manual transaxle assembly | 64 | 653 | 47 | ||||
| Engine mounting insulator LH x Automatic transaxle assembly | 95 | 969 | 70 | ||||
| Engine mounting insulator RH x Engine mounting bracket RH | 95 | 969 | 70 | ||||
| Front engine mounting insulator x Front engine mounting bracket | 87 | 887 | 64 | ||||
| Engine lateral control rod x Front flame | 52 | 530 | 38 | ||||
| Engine lateral control rod x No. 2 rear engine mounting bracket | 89 | 908 | 66 | ||||
| Rear engine mounting bracket x Cylinder block | 64 | 653 | 47 | ||||
| No. 2 rear engine mounting bracket x Rear engine mounting bracket | 64 | 653 | 47 | ||||
| Drive shaft bearing bracket x Cylinder block sub-assembly | 64 | 653 | 47 | ||||
| Frame side rail plates RH and LH x Body | Bolt A | 85 | 867 | 63 | |||
| Bolt B | 32 | 326 | 24 | ||||
| Front suspension member rear braces RH and LH x Body | Bolt C | 85 | 867 | 63 | |||
| Bolt D | 32 | 326 | 24 | ||||
| Drive plate and torque converter setting bolt x Torque converter | 41 | 418 | 30 | ||||
| Flexible hose tube x Clutch hose | 15 | 153 | 11 | ||||
| Engine moving control rod sub-assembly x Engine mounting bracket RH | 38 | 387 | 28 | ||||
| No. 2 engine mounting stay RH x Engine moving control rod sub-assembly | 38 | 387 | 28 | ||||
| No. 2 engine mounting stay RH x Camshaft housing sub-assembly | 38 | 387 | 28 | ||||
| Earth wire x Engine moving control rod bracket | 8.0 | 82 | 71 | ||||
| Engine wire x Engine room relay block | 8.0 | 82 | 71 | ||||
| Engine moving control rod sub-assembly x Body | 38 | 387 | 28 | ||||
| Transmission control cable x Control shaft lever | 13 | 133 | 10 | ||||
| No. 1 air cleaner bracket x Body | 8.0 | 82 | 71 | ||||
| Inlet air cleaner assembly x Body | 8.0 | 82 | 71 | ||||
| Air cleaner case sub-assembly x No. 2 air cleaner bracket | 5.0 | 51 | 44 | ||||
| Battery clamp x Body | Bolt | 9.0 | 92 | 80 | |||
| Nut | 3.5 | 36 | 31 | ||||
| Positive (+) cable x Positive (+) battery terminal | 6.9 | 70 | 61 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Stud bolt x Stiffening crankcase assembly | Stud bolt A | 9.5 | 97 | 84 | |||
| Stud bolt B | 4.0 | 41 | 35 | ||||
| Engine balancer assembly x Stiffening crankcase | 24 | 245 | 18 | ||||
| Stiffening crankcase assembly x Cylinder block sub-assembly | Bolt A | 24 | 245 | 18 | |||
| except Bolt A | 43 | 438 | 32 | ||||
| No. 1 oil pan baffle plate x Stiffening crankcase assembly | 10 | 102 | 7 | ||||
| Oil strainer x Stiffening crankcase assembly | 9.0 | 92 | 80 | ||||
| Oil pan sub-assembly x Stiffening crankcase | 10 | 102 | 7 | ||||
| Stud bolt x Camshaft housing sub-assembly | 6.5 | 66 | 58 | ||||
| Timing chain cover plate x Timing chain cover sub-assembly | 10 | 102 | 7 | ||||
| Timing chain cover tight plug x Timing chain cover sub-assembly | 30 | 306 | 22 | ||||
| Cylinder head cover sub-assembly x Camshaft housing sub-assembly | 12 | 122 | 9 | ||||
| Crankshaft pulley x Crankshaft | 260 | 2651 | 192 | ||||
| Water inlet housing x Cylinder block sub-assembly | 43 | 438 | 32 | ||||
| V-ribbed belt tensioner assembly x Water inlet housing | 21 | 214 | 15 | ||||
| No. 1 water by-pass pipe x Water inlet housing and Cylinder block sub-assembly | 10 | 102 | 7 | ||||
| Separator case x Ventilation case sub-assembly | 10 | 102 | 7 | ||||
| Ventilation case sub-assembly x Cylinder block sub-assembly | 21 | 214 | 15 | ||||
| Engine cover joint x Cylinder head cover sub-assembly and Camshaft housing sub-assembly | 10 | 102 | 7 | ||||
| Sensor wire x Cylinder block sub-assembly | 21 | 214 | 15 | ||||
| No. 1 compressor mounting bracket x Cylinder block sub-assembly and Stiffening crankcase assembly | 21 | 214 | 15 | ||||
| Engine oil level dipstick guide x Inlet water housing | 10 | 102 | 7 | ||||
| No. 1 and No. 2 engine hanger x Cylinder head sub-assembly | 43 | 438 | 32 | ||||