Home › General › SPECIFICATIONS › 2AR-FE COOLING
RM19V0EQ _V1 General _014571 SPECIFICATIONS _0073862 2AR-FE COOLING F

SPECIFICATIONS  2AR-FE COOLING  SERVICE DATA  


THERMOSTAT
Condition Specified Condition
Standard valve opening temperature 80 to 84°C (176 to 183°F)
Standard valve lift 10 mm (0.394 in.) or more at 95°C (203°F)

COOLING FAN MOTOR
Item Code Mark Condition Specified Condition
Cooling fan motor S Battery voltage applied at 20°C (68°F) 7.4 to 11.4 A
M 7.7 to 11.7 A
No. 2 cooling fan motor S Battery voltage applied at 20°C (68°F) 7.4 to 11.4 A
M 7.7 to 11.7 A

COOLING FAN RELAY
Tester Connection Condition Specified Condition
3 - 4 Battery voltage not applied between terminals 1 and 2 Below 1 Ω
3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
3 - 4 Battery voltage applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Battery voltage applied between terminals 1 and 2 Below 1 Ω

RADIATOR
Item Condition Specified Condition
Radiator cap Standard value (for brand-new cap) 93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard value (for used cap) 78.5 kPa (0.8 kgf/cm2, 11.4 psi)

COOLANT
Code Mark Capacity Classification
Code Mark "A" and "B" 7.9 liters (8.3 US qts, 7.0 lmp. qts) Use only "TOYOTA Super Long Life Coolant", or similar high qualityethylene glycol based non-silicate, non-amine, non-nitrite, and nonboratecoolant with long-life hybrid organic acid technology (coolantwith long-life hybrid organic acid technology is a combination of lowphosphates and organic acids).
Code Mark "D" and "U" 7.5 liters (7.9 US qts, 6.6 lmp. qts)