Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073912 CAMSHAFT OIL CONTROL VALVE G

2AR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Start the engine.


c.

Turn the intelligent tester on.


d.

Turn the A/C switch on.


e.

Inspect the camshaft timing oil control valve assembly (for intake camshaft).

i.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Linear (Bank 1).

Powertrain > Engine and ECT > Active Test
Tester Display
Control the VVT Linear (Bank1)
50004 234 32

ii.

Check the engine speed while operating the camshaft timing oil control valve assembly (for intake camshaft) using the intelligent tester.

Standard Condition:
Tester Operation Specified Condition
0% Normal engine speed
100% Engine idles roughly or stalls


HINT:

If the result is not acceptable, cool the engine (engine coolant temperature is 50°C (122°F) or less) and perform the Active Test again.




f.

Inspect the camshaft timing oil control valve assembly (for exhaust camshaft).

i.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Exhaust Linear (Bank 1).

Powertrain > Engine and ECT > Active Test
Tester Display
Control the VVT Exhaust Linear (Bank1)
50004 234 87

ii.

Check the engine speed while operating the camshaft timing oil control valve assembly (for exhaust camshaft) using the intelligent tester.

Standard Condition:
Tester Operation Specified Condition
0% Normal engine speed
100% Engine idles roughly or stalls


HINT:

If the result is not acceptable, cool the engine (engine coolant temperature is 50°C (122°F) or less) and perform the Active Test again.