Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › THROTTLE BODY
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073913 THROTTLE BODY G

2AR-FE ENGINE CONTROL  THROTTLE BODY  INSPECTION  


PROCEDURE

Hide 22030 1.INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY

a.

Check that the throttle valve opens and closes smoothly.


b.

Check that there is no sludge accumulated around the throttle with motor body assembly.


c.
A195072
2.083,3.729 1.698,4.115 false 2.313,3.74 2.531,4.115 false 0.719,2.99 1.021,3.24 0.302,0.25 10 false *a 2.479,4.146 2.927,4.438 0.448,0.292 10 false M- 1.604,4.146 2.177,4.521 0.573,0.375 10 false M+
*a Component without harness connected
(Throttle with Motor Body Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (M-) - 2 (M+) 20°C (68°F) 0.3 to 100 Ω


If the result is not as specified, replace the throttle with motor body assembly.