Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › MASS AIR FLOW METER
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073916 MASS AIR FLOW METER G

2AR-FE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

a.
A190679
0.74,2.135 0.688,0.802 0.688,0.802 0.521,0.802 false 0.344,0.74 0.594,0.938 0.25,0.198 10 false *1
*1 Platinum Hot Wire (Heater)


Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter sub-assembly shown in the illustration.

OK:

There is no foreign matter.



b.

Check the intake air temperature sensor (built into the mass air flow meter sub-assembly).

i.
A196153
1.917,1.406 2.052,1.865 2.052,1.865 2.135,1.865 false 2.146,1.313 2.469,1.052 2.469,1.052 2.594,1.052 false 0.302,0.188 0.583,0.406 0.281,0.219 10 false *a 2.156,1.792 2.5,2.042 0.344,0.25 10 false E2 2.667,0.958 3.073,1.177 0.406,0.219 10 false THA
*a Component without harness connected
(Mass Air Flow Meter Sub-assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (THA) - 2 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
1 (THA) - 2 (E2) 20°C (68°F) 2.21 to 2.69 kΩ
1 (THA) - 2 (E2) 60°C (140°F) 0.49 to 0.67 kΩ


If the result is not as specified, replace the mass air flow meter sub-assembly.