Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2011.10–2015.04
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073918 CRANKSHAFT POSITION SENSOR A

2AR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Clean and degrease the threads of the bolt for the crankshaft position sensor.


b.
A157503
2.146,0.354 2.021,0.354 2.021,0.354 1.833,0.844 false 2.177,0.271 2.667,0.458 0.49,0.188 10 false *1
*1 O-ring


Apply a light coat of engine oil to the O-ring of the sensor.


c.
A192239C48
1.885,1.583 1.802,1.885 1.802,1.885 1.688,1.885 false 1.49,1.802 1.76,1.979 0.271,0.177 10 false *1
*1 Adhesive


Apply adhesive to 2 or 3 threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.



d.

Install the sensor with the bolt.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)

NOTICE:

Make sure that the O-ring is not cracked or does not jump out of position during installation.



e.

Connect the sensor connector.


Hide 2.INSPECT FOR OIL LEAK