Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073920 ENGINE COOLANT TEMPERATURE SENSOR G

2AR-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 89422 1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR

A214444
5.99,1.146 6.333,0.688 6.333,0.688 6.427,0.688 false 0.75,1 1.073,1.24 0.323,0.24 10 false *a 5.906,2.594 6.26,2.792 0.354,0.198 10 false *b 4.75,0.51 5.115,0.781 0.365,0.271 10 false *c 6.479,0.625 6.667,0.906 0.188,0.281 10 false *d
*a Component without harness connected
(Engine Coolant Temperature Sensor)
*b Temperature °C (°F)
*c Resistance Ω *d Acceptable


a.

Partially immerse the sensor in water and warm up the water.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 2.32 to 2.59 kΩ
1 - 2 80°C (176°F) 0.310 to 0.326 kΩ


NOTICE:

When checking the sensor in water, keep the terminals dry. After the check, wipe the sensor dry.


If the result is not as specified, replace the engine coolant temperature sensor.