Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073922 AIR FUEL RATIO SENSOR G

2AR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSPECTION  


PROCEDURE

Hide 89467B 1.INSPECT AIR FUEL RATIO SENSOR

a.
A183494
1.99,1.198 2.594,1.146 false 1.448,1.188 0.865,1.094 false 1.438,1.604 0.875,1.667 false 2.635,1.073 3.24,1.281 0.604,0.208 10 false HA1A 0.646,1.01 0.958,1.25 0.313,0.24 10 false +B 0.521,1.594 1.063,1.802 0.542,0.208 10 false A1A- 0.135,0.125 0.448,0.427 0.313,0.302 10 false *a
*a Component without harness connected
(Air Fuel Ratio Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HA1A) - 2 (+B) 20°C (68°F) 1.6 to 3.2 Ω
1 (HA1A) - 4 (A1A-) Always 10 kΩ or higher


If the result is not as specified, replace the air fuel ratio sensor.