Home › Engine / Hybrid System › 2AR-FE ENGINE MECHANICAL › DRIVE BELT
RM19V0EQ _51 Engine / Hybrid System _014574 2AR-FE ENGINE MECHANICAL _0073926 DRIVE BELT A

2AR-FE ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 16361A 1.INSTALL V-RIBBED BELT

a.
A194911
2.125,0.281 2.323,0.281 2.323,0.281 2.698,0.594 false 3.083,1.219 2.938,1.219 2.938,1.219 2.708,1.396 false 1.26,0.688 1.438,0.688 1.438,0.688 1.688,0.948 false 0.448,1.406 0.594,1.406 0.594,1.406 0.781,1.792 false 2.073,3.24 2.219,3.24 2.219,3.24 2.375,3.01 false 0.24,1.344 0.406,1.5 0.167,0.156 10 false *1 1.938,0.208 2.104,0.396 0.167,0.188 10 false *3 1.063,0.594 1.24,0.76 0.177,0.167 10 false *2 1.885,3.156 2.042,3.323 0.156,0.167 10 false *5 3.125,1.146 3.281,1.292 0.156,0.146 10 false *4
*1 Crankshaft
*2 Tensioner
*3 Generator
*4 Water Pump
*5 Cooler Compressor


Set the V-ribbed belt onto each part as shown in the illustration except the water pump pulley.


b.

Loosen the V-ribbed belt by turning the belt tensioner clockwise.


c.

Set the V-ribbed belt onto the water pump pulley.

NOTICE:

Make sure that the belt is attached to each pulley. In particular, make sure that the belt is securely fitted into the grooves of the crankshaft pulley.



Hide 53736 2.INSTALL FRONT FENDER APRON SEAL RH

Hide 51441C 3.INSTALL ENGINE UNDER COVER RH

Hide 53851Z 4.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)

Hide 5.INSTALL FRONT WHEEL RH

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)