Home › Engine / Hybrid System › 2AR-FE FUEL › FUEL SENDER GAUGE ASSEMBLY
RM19V0EQ _51 Engine / Hybrid System _014575 2AR-FE FUEL _0073941 FUEL SENDER GAUGE ASSEMBLY G

2AR-FE FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.
A255952
0.167,0.115 1.948,1.427 1.781,1.313 1.396,3.906 0.792,3.906 false 1.771,2.365 0.958,2.365 false 0.271,0.219 0.646,0.646 0.375,0.427 10 false *a 0.771,2.281 1.042,2.542 0.271,0.26 10 false F 0.615,3.833 0.917,4.104 0.302,0.271 10 false E
*a Front view of wire harness connector
(to Fuel Sender Gauge Assembly)


Check that the float moves smoothly between F and E.


b.

Measure the resistance between the terminals 1 and 2 of connector according to the value(s) in the table below.

Standard Resistance:
Float Level Resistance (Ω)
F 13.5 to 16.5
Between E and F 13.5 to 414.5 (Gradually changes)
E 405.5 to 414.5


If the value is not as specified, replace the fuel sender gauge assembly.