Home › Engine / Hybrid System › 2AR-FE EMISSION CONTROL › EMISSION CONTROL SYSTEM
RM19V0EQ _51 Engine / Hybrid System _014576 2AR-FE EMISSION CONTROL _0073942 EMISSION CONTROL SYSTEM G

2AR-FE EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL CUT RPM

a.

Increase the engine speed to at least 3500 rpm.


b.
A195987C02
2.25,1.5 2.063,1.5 2.063,1.5 1.875,0.875 true 2.271,1.385 2.625,1.646 0.354,0.26 10 false *1
*1 Sound Scope


Use a sound scope to check for injector operating sounds.


c.

When the accelerator pedal is released, check that injector operating sounds stop momentarily and then resume.

Standard:
Item Specified Condition
Fuel injection restart rpm 1400 rpm


If the result is not as specified, check the injectors, wiring and ECM.


Hide 2.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

a.

Inspect the hoses and gaskets for scratches, cracks and air/oil leaks from the connecting parts.

HINT:

If the hoses or gaskets are damaged or some of the connections are loose, they may cause an engine stall or malfunction.



Hide 3.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM

a.

Connect the intelligent tester to the DLC3.


b.
A254746

Disconnect the fuel vapor feed hose from the purge VSV shown in the illustration.


c.

Start the engine.


d.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.

Powertrain > Engine and ECT > Active Test
Tester Display
Activate the VSV for Evap Control
50004 234 6

e.

Check that vacuum occurs at the purge VSV port.


f.

If vacuum does not occur, check the following items:

HINT:
·

Purge VSV (for canister purge)

·

Clogging in the fuel vapor feed hose connecting the intake manifold and purge VSV

·



g.

Exit Active Test mode and reconnect the fuel vapor feed hose.


h.

Enter the following menus: Powertrain / Engine and ECT / Data List / EVAP Purge VSV.

Powertrain > Engine and ECT > Data List
Tester Display
EVAP Purge VSV
50003 234 217

i.

Warm up the engine and drive the vehicle.


j.

Confirm that the purge VSV opens.

If the result is not as specified, replace the purge VSV, wire harness or ECM.