Home › Engine / Hybrid System › 2AR-FE EMISSION CONTROL › PURGE VALVE
RM19V0EQ _51 Engine / Hybrid System _014576 2AR-FE EMISSION CONTROL _0073944 PURGE VALVE G

2AR-FE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT PURGE VSV

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω


If the result is not as specified, replace the purge VSV.


b.
A124792
1.073,1.646 1.198,1.646 1.198,1.646 1.323,1.188 false 1.813,1.302 1.813,1.698 false 2.896,1.573 3.063,1.719 0.167,0.146 10 *c 0.896,1.552 1.125,1.75 0.229,0.198 10 *b 1.729,1.729 1.927,1.917 0.198,0.188 10 *a
*a Port E
*b Port F
*c Air


Apply battery voltage between the terminals of the purge VSV and check that the following occurs when blowing air into port E.

OK:
Measurement Condition Specified Condition
Battery voltage applied between terminals 1 and 2 Air flows from port F.
Battery voltage not applied between terminals 1 and 2 Air does not flow.


If the result is not as specified, replace the purge VSV.