Home › Engine / Hybrid System › 2AR-FE COOLING › RADIATOR
RM19V0EQ _51 Engine / Hybrid System _014578 2AR-FE COOLING _0073959 RADIATOR G

2AR-FE COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16401 1.CHECK RADIATOR CAP SUB-ASSEMBLY

a.
A107446
1.063,1.667 1.271,1.875 0.208,0.208 10 false 3 0.49,1.073 0.667,1.271 0.177,0.198 10 false 1 0.719,1.365 0.906,1.573 0.188,0.208 10 false 2 2.417,1.531 2.573,1.719 0.156,0.188 10 false 4

Measure the valve opening pressure.

i.

If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the part(s) with water and finger scouring.


ii.

Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.


iii.

Check that 3 and 4 are not stuck together.


iv.

Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.


v.

When using the cap tester, tilt it upward 30° or more.


vi.
A104601
0.417,0.854 0.417,1.479 0.417,1.479 0.594,1.479 false 1.656,0.802 1.823,0.542 1.823,0.542 2.052,0.542 false 2.177,0.448 2.469,0.646 0.292,0.198 10 false *1 1.542,1.323 1.823,1.542 0.281,0.219 10 false *a 0.698,1.427 1.01,1.656 0.313,0.229 10 false *2
*1 Radiator Cap Tester
*2 Radiator Cap Sub-assembly
*a 30° or more


Pump the cap tester several times, and check the maximum pressure*1.

Pumping speed:

1 pump every second


*1: Even if the cap cannot maintain the maximum pressure, it is not a defect.

Judgment Criterion:
Item Specified Condition
Standard value
(for brand-new cap)
93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard value
(for used cap)
78.5 kPa (0.8 kgf/cm2, 11.4 psi)


If the maximum pressure is less than the specified pressure for the minimum standard value, replace the radiator cap sub-assembly.